Quicktrim Check Corner Internal Black

£4.88 inc. VAT £4.07 exc. VAT

Quicktrim is a specially designed edge trim system used for completing EPDM flat roofs. It is quick and easy to install, environmentally friendly and long lasting.

Read More

  • Description
  • Technical Specifications
  • Size Guide
  • Installation Guide
Description

Quicktrim Check Corner Internal Black

Quicktrim is a specially designed edge trim system used for completing EPDM flat roofs. It is quick and easy to install, environmentally friendly and long lasting. Quicktrim Check Internal Corners are used to finish a corner of the roof where two Check Kerb trims, or a Check Kerb and a Drip Edge, meet on an internal corner.

Suitable For:

Internal corners
Use with Check Kerb trim
Corners between Check Kerb and
Gutter Drip Trim

Technical Specifications

Quicktrim is supplied with:
Compression foam attached to the trim
Joint clips for adding additional lengths
Pins for fixing the trim

Size Guide

One size: 80mm x 80mm
For internal corners

Installation Guides

Corners should be installed before the outer lengths of both Gutter Drip and Check Kerbs (the inner back plate of Drip Edges must be installed first).

1. After laying the membrane, neaten any corners so there are no steps or bulges

2. Press the corner firmly into place and secure through the pre-drilled holes using the fixings provided

3. Do not over tighten the fixing nails against the trim face

4. Where the corner is the interchange between Gutter Drip and Check Kerbs, use the brass nail on the Drip side, apply a bead of Sealant over this and fit a joint clip to cover. The end of the joint clip can be filled with Sealant to fully seal the corner

Full guide to installing Quicktrim

£4.88 £4.07