225mm (9") EPDM Flashing Tape
EPDMÂ Flashing Tape is extremely flexible and can be formed to fit irregular shapes and surfaces, making it perfect for a range of detailing requirements.
- Technical Specifications
- Size Guide
- Installation Guide
225mm (9") EPDM Flashing Tape
EPDM flashing tape is extremely flexible and can be formed to fit irregular shapes and surfaces, making it perfect for a range of detailing requirements for roofing projects. It is especially useful for flashing around external corners, pipe penetrations and drain outlets to help make them waterproof. Flashing Tape consists of an uncured EPDM membrane that has been laminated to an EPDM pressure sensitive tape adhesive. Before application of EPDM flashing, all work surfaces must be clean, dry, and free from dirt or other debris. Flashing Tape must always be used with Tape Primer which will provide optimal adhesion of the tape to the surface of the area it’s applied to.
Overlay at T-joints, corners, pipes and penetrations
General repair in non-traffic areas & metal edge tie-in
General purpose flashing
Width: 229mm (9 inches)
Length: sold in linear metres, max 15.24m in a single piece
All work surfaces must be clean, dry, and free of dirt.
1. Apply Tape Primer to the whole area the Flashing Tape will be applied to and leave to tack off
2. Install the Flashing Tape over the primed area
3. Firmly roll the Flashing Tape to create a strong bond
4. Finish with Lap Sealant to provide additional protection
See our guide to installing an external corner with flashing tape